It is always worth taking a look at the extent to which technical interfaces can be optimized by small adjustments, which then often have a large effect. Whether it is about geometric objects, pure data sets or combinations thereof, the problem does not get any smaller. Technical interfaces always have potential for optimization, because what is written on one side is not always what is read or expected on the other. Of course, each macro is delivered with documentation and application video and set up remotely on your computer by me. This saves a lot of time and reduces error sources in case of changes. after changing the geometry or exchange of members.

The nodes, which are generated by the macros, can be recalculated e.g. In addition, a significant increase in quality and individuality can also be achieved.Įvery macro I create for you is “open” and can even be modified by you if you have the necessary expertise. The time gained can then be used for further business development, for example. Then you decide what should be implemented and when.Įxperience has shown that in the 3 cases mentioned above, time savings of between 20 and 70 % can be achieved if the changes are taken into account, which in practice always represent a major challenge in an ongoing project. From this the specifications for a macro development result directly and I can give you immediately a specific estimate over the expenditure. I analyse these 3 basic situations together with you during my consultation.

These always have a considerable potential for optimization. Systematic or standardized structures are certainly not commonplace for everyone, but still occur frequently in practice. However, due to their multitude and parametric variation, these represent a particular challenge that can be made significantly more effective by analysis and optimization. With geometrically special projects, new nodes and details often occur that have never been seen before. This is usually not directly noticeable or is accepted in the workflow without suspecting that there is a considerable opportunity for optimization in terms of time and quality. When using AVEVA Bocad, points of detail occur again and again, some of which are completely or at least principally the same as those of other projects.

The offers are formulated for users of AVEVA Bocad in the areas of steel construction, timber construction, roof & wall, tower, onshore and offshore. In the following you will find a selection of my offers in the AVEVA Bocad environment.

Bocad 3d software